First remove C600:
Then prepare the board, I scraped of some solder mask so I could solder.
I used an SDcard connector from an old univeral reader, bought a new one that also supported >1GB cards.
This one has a metal cover, easy to solder on, used some 2 component glue too.
Make sure you position it so it does not short any of the resistors, there is just enough space.
The connection to the SES and reset switch I made on the backside of the PCB (not shown).
Now solder in the SDcard connector ,and connect the wires.
Ground from the SES switch metal:
Signals from the right hand side of the white and yellow LED under the SES switch.
Yes I accidently killed the white LED, and removed it (was too bright anyways).
Power +3.3V from the red LED:
Yes we have a serial port too:
The end result:
Back to the wap54g page
more Linux GPL soft I wrote